TMPRO SW VW PASSAT 3C (B6/CC) TM - Dr Lock Shop

Purchased to order - Maxium 24 hours

Software module 149- VW Passat 3C comfort and ECU with ID48

Depending on job with car you have these options:

1.If job isNEED SPARE KEY,you needONLYfile fromcomfortunit.

2.If job isLOST ALL KEYS,after loading ofcomfort filesoftware offers to you 3 options:

• 1- load file from engine ECU.Supported are EDC16,MED9not cryptedand SIMOS PPD
• 2- enter first 6 bytes of component security.Use any tool to read them by OBD2

If you use one of these 2 options,software will save new file for comfort unit and will program key.You must program comfort with new file and car will start with programmed key.
If with your carECU file is cryptedor you can`t readfirst 6 bytes of CSyour solution is

• make attempts with key until adopted by car.Use this option whenECU file is cryptedor no way to read first 6 bytes of component security.Software will save new file and you must program comfort with it.After that you must do this sequence "program key with TMPro - try key in car" until car starts with new key. Maximal number of attempts is 256.Time for one attempt "program key with TMPro - try key in car" is no more than 15 seconds.

For engine ECU supported are EDC16 with eeprom 95c320,MED9 with 95c080 and Siemens SIMOS PPD with 95c320.For comfort unit eeprom is 95c320.
Use Megamos Crypto or Silca T6 transponder.
Written transponder is ready programmed to start the vehicle.
Software also shows PIN code.

Vehicles equipped with this unit:
VW:Passat 3C (B6/CC)